Metso C series jaw crusher in the frame, the movable jaw bearing assembly, flywheel, motor and domestic machine is also equipped with the same configuration, the hopper hopper or the size of design, can effectively prevent the crusher wear protection, and from direct impact. The feed end of a louver protective cover, to prevent in the crushing process in the operator to observe the crushing cavity, flying out of the stone splash hurt eyes.
The discharge chamber is provided with a partition board, the formation of crushing material “cushion” under falling ore impact absorption material to most of the impact force before the transport belt, thereby increasing the service life of the belt transport.C80 blanking position since the belt protector (protector adjustable angle), falling angle protector by direct touch to change into the horizontal belt machine, so as to avoid the damage of a conveying belt.
The movable jaw body and a front frame between the door plate, the discharging port using a smaller (usually greater than or equal to the minimum recommended discharge port) or broken (very hard rock crushing rate is very low) when using protective plate. This provides additional protection for the front frame and the movable jaw body.
Schematic diagram of C80 jaw crusher
1- frame; wedge 2-; 3- filling wedge; 4- plug bolt; 5- disc spring cover; 6-; 7- (on the cheek) fixed jaw plate (a); 8- (a); the movable jaw plate 9- cheek plate (below); 10- fixed jaw plate (lower); 11- movable jaw in (the); 12- fixed wedge; 13- and eye protection plate; 14- flywheel; 15- eccentric shaft; 16- and bearing; 17- and 18-; a frame connecting rod; 19- plate; 20- frame bolt; 21- frame; 22- adjusting wedge; 23- gasket; 24- floor plate 25,28- rib; Board seat; 26- thrust sleeve locking nut; 27- tension spring; 29- rib; 30- tension bar
The integral support frame directly bolted in the crusher (end plate), the drive motor is installed on the bracket, the bracket seat plate thickness is 16mm, 30mm connecting rod, the motor has the advantages of simple installation, installation of light steel structure frame, only need to install a small space.
Hunan Fengwei Wear Parts Foundry mainly engaged in casting Metso,Sandvik crusher accessories, mainly the production of jaw crusher accessories (tooth plate, backplate,pressing plate), cone crusher accessories (rolling mortar wall, broken wall, lining plate, pressure sleeve etc.), accessories (ball mill lining board, steel ball etc.), impact crusher (blow bar, liner), hammer crusher, roller crusher of roller wear products and various accessories. In addition we wear resistant alloy and a special dredging vessel chain plate, sand pump Straw chain plate production line, achieves the perfect combination of wear resistance and toughness the users all over the country and supporting around the shipyard, Straw uses a unique recipe and The heat treatment process, the service life is ordinary alloy straw more than three times. Honesty is the foundation of life, quality is the enterprise development life, is willing to wholeheartedly cooperate with you! Welcome friends to map call customization
Contact:Sales Director: Eileen Cai ;
Email: sales@hnfwe.com;
WhatsApp: +8618692872223