1. Oversupply When the feeding material is too much, the broken cavity will be full, which will bring the crusher a great pressure, and finally make the cone break overload operation. For a long time, ...

1. Considerations in use During the operation of the cone crusher, the materials in the equipment must conform to the requirements of crushing. It is strictly forbidden that the hardness is too large, ...

Prevention of frequent cone breakage of iron, mainly from the following three aspects: 1. Strengthen the spot inspection of the wear condition of the belt funnel liner, and replace the problem in time ...

1. Fixed tooth plate with skew wedge positioning 2, most effective meshing angle, efficient geometry 3, the hydraulic adjusting wedge can adjust the discharge port quickly when the product needs to be ...

Analysis of the reason for the reduction of crushing capacity of CS cone crusher in Sh endv ick Reasons: 1,because of the smaller feed opening of the lower worn acetabular wall, the ore is restricted f...